Installation advice

PVC has a heat expansion coefficient that must be taken into consideration when installing.

If the products are stored in premises that are not heated in winter or exposed to excessive direct sunlight in summer, they must compulsorily be moved to the installation site and weathered at service temperature 24 hours prior to installation.

If the products will be exposed to direct sunlight through windows or in a confined space (such as a glazed walkway, for instance), install with appropriate expansion joints. Please consult us.

For Decosheet panels installed as full or half-height protection in areas exposed to temperature variations greater than 10°C, install with appropriate expansion joints.

If the products are to be installed in temperature conditions very different to 20°C (such as unheated premises in winter), take into account dimensional variations indicated in the below table.

Temperature en °C	Dimensional variations in mm (for 1 linear meter)	Comments
15	- 1 mm	Minimum temperature
20 (ideal temp.)	0	Ideal temperature
25	+ 1 mm	Admissible temperature
30	+ 2 mm	Maximum temperature

Do not undertake installation work in ambient temperature conditions below 15° C or above 30°C.

All SPM products are designed to be installed inside the buildings.

STOCKING
Caution: store products flat and inside

INSTALLATION
Packed delivered with installation advice sheet

ASSISTANCE
For any advice or question, please contact us.